correct_velocity
This keyword allows one to enforce zero linear and angular momenta at regular intervals.
Syntax
This keyword takes a correction interval and an optional grouping method:
correct_velocity <interval> [<group_method>]
Parameters
intervalis an integer number of MD steps and must be at least 10. A value between 10 and 100 should be good.When
group_methodis omitted, the correction applies to the whole system. When it is specified, the correction is performed independently for every group in that grouping method defined inmodel.xyz.
Output
None.
Examples
Example 1
The command:
correct_velocity 10
implies that the linear and angular momenta are set to zero every 10 steps.
Example 2
The command:
correct_velocity 50 3
implies that the linear and angular momenta for the individual groups in group method 3 are set to zero every 50 steps.
Notes
The first correction is performed before the first integration step, and subsequent corrections occur every interval steps.
For example, an interval of 10 gives corrections before steps 1, 11, 21, and so on.
Periodic correction is disabled by default and only applies to the current run when enabled.
Repeat this command before each subsequent run that needs it.